Skip to content

Rugged Mesh · Flexible Pixel Mesh

R M

Double-sided RGB pixel mesh for media façades, curtain walls and suspended installations. Each node carries two independently addressable pixels, one per face, so the net shows content from both sides. Nodes sit on a 238 mm grid of stainless steel wire rope, with runs of up to 150 m per power unit.

  • Colour RGB · Double-sided
  • Build IP66 · Stainless wire rope
  • Pitch 238 mm · Custom available
  • Control SPI · Dual-signal data
Configure Your Product View Specifications
RXM Rugged Mesh render, RGB pixel nodes on stainless steel wire rope with power and data leads

Key Specifications — RXM Rugged Mesh

Electrical
Power Consumption 2.6 W per node (default) / 3.5 W per node (max)
Operating Voltage 24 V DC
Max Run Length 150 m per power unit
Physical
Node Dimensions L: 40 mm – H: 48 mm (63 mm including cable clamps)
Pitch 238 mm (standard) / customised options available
Nodes per String 50 (standard) / customised lengths available
Mounting Options Stainless steel wire rope with turnbuckles and U-clips, bracket mount
Optical
Colour Range
RGB RGB
Emission Double-sided (front and rear)
Beam Angle 120°
Dimming & Control
Control Protocol
SPI SPI
Data Redundancy Dual-signal
Pixels per Node 2 (independent IC per side)
Dimming Resolution 12-bit (4,096 grey levels) per channel
Ratings & Warranty
Protection Rating
IP rating icon IP66
Certifications CE, RoHS
Limited Warranty 5 years (extendable warranty available)

Note: Summary of the RXM datasheet. The full datasheet is in Downloads.

Node Dimensions
RXM node dimensions: side A and side B views, 238.1 mm pitch, 40 × 48 mm node, 63 mm including cable clamps, Ø22.8 mm and Ø21.9 mm lens domes

Downloads

RXM Rugged Mesh Downloads

Specifications

RXM_Rugged_Mesh_Specifications_Sheet.pdf

Product Configurator

Interactive Configurator

Configure RXM for Your Project

Set node quantity, pitch and mounting, then generate a build-ready RXM configuration for your installation.

  • Live 3D Preview
  • Rule-Validated Options
  • Instant Part Number

Frequently Asked Questions

9 Questions

Common questions, answered.

A double-sided RGB pixel net for large-scale media façades, curtain walls and suspended installations.
Yes. Each node carries two independently addressable RGB pixels, one per face, each with its own driver IC. The same net shows content front and rear.
Nodes sit on a 238 mm grid as standard, with custom pitches available. A standard string has 50 nodes, and custom lengths are available.
The nodes hang from stainless steel wire rope with turnbuckles and U-clips. A bracket mount is also available.
Up to 150 m per power unit. Each run needs at least 21 V DC at its input, and the PSU needs at least 20% headroom over the total load.
It runs on SPI with dual-signal data redundancy, through a UCS5603A driver IC. Dimming is 12-bit (4,096 grey levels) per channel, and one data line carries up to 370 pixels at 60 fps or 740 at 30 fps.
24 V DC. Each node draws 2.6 W by default and 3.5 W at most, at 110 mA (default) to 144 mA (max).
Yes. It’s rated IP66 for water and dust, carries CE and RoHS, and the housing meets UL 94-V2 minimum.
Source life is 50,000 hours. The warranty is 5 years, and you can extend it.